Before installation
Use a supported Linux image and a plan that meets the application requirements. Back up any existing workload. Confirm DNS, free disk space, and required ports before approving the installer.
Install from the client panel
- Open the purchased VPS and choose Install application.
- Select WireGuard and review compatibility, estimated time, and the exact plan.
- Confirm the server identity and backup warning.
- Follow installation progress from the task page. Do not run the installer twice.
The VPS can show Active while application setup is still finishing. Wait for Ready or review the reported result before using it.
First setup
Create a separate peer profile for each device. Allow the configured UDP listening port, commonly 51820, and verify forwarding or NAT only when your design requires it. Never share a peer private key.
Troubleshooting
Check the installation result, VPS power state, DNS, required ports, free storage, memory, service or container status, and the first relevant log error. Preserve logs before retrying. If the task needs attention, open a support ticket instead of rebuilding the VPS.
Backup and recovery
Back up the server configuration and peer public-key inventory securely. Revoke a lost device by removing its peer and issuing a new profile.
Official documentation
Review the current WireGuard documentation before production changes.